telescopeWizard telescopeWizard 0 1 609 300 5 5 0 0 500 300 800 300 Telescope Wizard true unnamed layout12 unnamed 10 helpB &Help false spacer2 Horizontal Expanding 56 11 backB &Back nextB &Next true true wizardContainer introPage 0 unnamed intoPageLabel 5 5 0 0 Welcome to the <b>KStars Telescope Setup Wizard!</b> <br><br> This Wizard will help you to connect to your telescope and control it from KStars. You will be asked to verify some basic information. <br> <br>You can get extended information on telescope support in KStars by pressing the <tt>help</tt> button at any point during the Wizard. <br><br> Please click next to continue. WordBreak|AlignVCenter modelPage 1 unnamed modelPageLabel <h3>1. Telescope Model</h3> Please select your telescope model from the list below. Click next after selecting a model. WordBreak|AlignTop spacer5_2 Vertical Expanding 20 25 layout10 unnamed telescopeCombo spacer3 Horizontal Minimum 196 16 spacer5 Vertical Expanding 20 25 textLabel1 <b>Tip</b> <br>Some non-Meade telescopes support a subset of the LX200 command set. Select <tt>LX200 Generic</tt> to control such devices. telescopePage 2 unnamed telescopePageInfo 5 5 0 0 <h3>2. Align Your Telescope</h3> You need to align your telescope before you can control it properly from KStars. Please refer to your telescope manual for alignment instructions. <br><br> After a successful alignment, connect your telescope's RS232 interface to your computer's serial or USB port. <br><br><br>Click next to continue. WordBreak|AlignTop localPage 3 unnamed localPageLabel <h3>3. Verify Local Settings</h3> Verify if the following time, date, and location settings are correct. If any of the settings are incorrect, you can correct them via the <tt>Set time</tt> and <tt>Set Location</tt> buttons. WordBreak|AlignTop spacer4_2_2 Vertical Expanding 20 20 layout14 unnamed layout13 unnamed layout6 unnamed layout2 unnamed timeLabel <b>Time</b> timeOut 1 layout3 unnamed dateLabel <b>Date</b> dateOut 1 layout4 unnamed locationLabel <b>Location</b> locationOut 1 layout11 unnamed setTimeB Set Time... setLocationB Set Location... spacer4_2 Vertical Expanding 20 40 portPage 4 unnamed portPageLabel 5 5 0 0 <h3>4. Determine Connection Port</h3> Enter the port number your telescope is connected to. If you only have one serial port in your computer, the port is usually <tt>/dev/ttyS0</tt> <br><br>If you are unsure about the port number, you can leave the field empty and KStars will try to scan the ports for attached telescopes. Beware that the autoscan process might take a few minutes to complete. WordBreak|AlignTop spacer6_2 Vertical Expanding 20 25 layout17 unnamed portLabel <b>Port:</b> portIn spacer4 Horizontal Expanding 141 16 spacer6 Vertical Expanding 20 25 wizardPix true klineedit.h